Freestanding Baths – Considerations When scouting for and Fitting a Waste Kit

Plug and Chain, Click Clack or Show up Waste
There are three basic kinds of waste kit. The regular plug and chain waste known to every one. A retainer plug and chain waste is a where the plug matches the overflow grill when not in use to maintain it out of the way. Plug and chain wastes usually feature sometimes a ball chain or a link chain. Most plug and chain wastes will fit most freestanding baths. A click clack waste is a using a sprung plug which operates like many contemporary basin wastes, you push the plug in and yes it clicks shut, push it again to click it open, with click clack wastes a chrome cover fits within the overflow hole but stands slightly satisfied with it so as to not block it. A show up waste is a that’s controlled by a chrome dial which fits within the overflow, a cable works on the away from the bath from the dial towards the plug and turning the dial causes the cable to maneuver and operate the plug. Most click clack and show up waste sold in major chains is not going to fit most traditional freestanding roll top baths.


Concealed or Exposed Waste Kit
A concealed waste kit is a that’s assumed being fitted in circumstances where the few parts which might be fitted inside the bath will be seen, in order that every one of the pipe work outside the bath – the overflow pipe, trap and outlet pipe may be plastic. An exposed waste kit ‘s all metal/chrome without plastic parts and it is all meant to be observed. A conventional double ended freestanding bath if placed about against a wall may be fitted using a concealed waste kit as the pipework will be hidden between your bath along with the wall. One particular ended traditional freestanding bath in most cases have all the pipework visible when viewed in profile wherever you install it so for these and for double ended baths which might be outside the wall you’d almost certainly fit an exposed waste kit using a chrome trap and outlet pipe.

Thickness of Freestanding Baths
Most traditional Freestanding Baths less complicated thicker than standard panel baths and also this may cause a problem with many waste kits. All waste kits have a parts that sit on both sides with the plug and overflow holes and connect together produce a sandwich structure using the wall with the bath is the sandwich filling and aspects of the waste kit on both sides. For plug and chain wastes the parts with the waste kits generally interact with a threaded bolt so as long since the bolts are of sufficient length (which they usually are) then these kits will fit on any thickness of overflow or plug hole. However most click clack and show up wastes use rather than a bolt a broad bore plastic threaded tube that could be only 7 to 12 mm thick, this isn’t hick enough for most traditional roll top baths.

Fitting a Trap with a Freestanding Bath
Freestanding baths either without or with feet will have reduced clearance underneath the bath plus a standard size bath trap may not fit between your bath along with the floor. If you are able to penetrate the bottom underneath the bath then this hole can be achieved in the floor for your trap to match into, you can definitely your floor is concrete or of for aesthetic reasons you simply can’t go into the floor then you will need to have a shallow or ultra shallow bath trap which you might need to get from the specialist.
For details about Freestanding Baths check our site: check

Leave a Reply